2Pcs 20V 2.0Ah Replacement Battery For Dew DCB180 DCB181 DCB200 Electric Hand Drill Electric Tools

Specification:

Note:

1. The newly purchased Ni MH and Ni Cd tool batteries should be used up and put aside for 20 minutes before charging for the first time;

2. The tool battery should not be charged immediately after use. It is recommended to put it aside for 30 minutes before charging, because the internal temperature of the battery pack may be high after use, and it is in a protected state, so the charger cannot recognize it;

3. If the tool battery may not be used for a long time after use, it is recommended to charge the battery for 20-30 minutes (no need to fully charge) within 2 days after use, so as to ensure that the battery will not be unable to charge when it is used again due to low voltage drop after long-term use;

4. During use, charging or storage, if the battery is found to be hot, emitting odor, discoloration, deformation or other abnormal phenomena, it shall be stopped immediately. The temperature during charging shall not be higher than 45 and that during discharging shall not be higher than 60 ;

5. If the speed and strength of the main engine are obviously insufficient during use, it is recommended to stop using the main engine in time to prevent irreversible damage to the battery cell caused by battery overdischarge, which is conducive to extending the battery life;

6. Pay attention to dust-proof, fire-proof, water-proof and anti-static during battery use or storage;

7. Use a special charger to charge according to the instructions;

8. Do not use metal to directly short the positive and negative electrodes of the battery, resulting in short circuit of the battery;

9. If the battery can’t be used, feed back the problem to the seller in time within the warranty period, and replace or repair it in time;

10. If a single cell is found to be abnormal, it is not allowed to find another cell to replace it.

Package Included:

2 Pcs x Replacement Battery